Copystar LightScribe - Section 2: Selecting the Copy Source to the Hard Drive; Section 3: Making Copies from an Existing Partition;Image of the Hard Drive

- 14 -
You can then press the “ENT”/Enter button to go back to the Hard Drive Setup menu. And
then press the “ESC”/Escape button to return to the Main menu. You should see the
following screen:
Section 2: Selecting the Copy Source to the Hard Drive.
Ignore this section and proceed to Section 3 if you have just completed Section 1:
Loading Master Disc content into the Hard Drive as an image as this process will
automatically switch the source to the hard drive.
Step1: Use the up or down arrow button to navigate to the Select Source menu.
Step2: Press “ENT”/Enter button to enter the Select Source menu and you shall see a
screen similar to below:
Step3: Use the up or down button to locate the Hard Drive and press the “ENT”/Enter
button to select it.
If the hard drive has already been pre-selected as the source, the system will NOT
respond to the “ENT”/Enter button. Please press the “ESC”/Escape button to go
back to the main menu.
Once the source has been selected, you will be guided to the Main menu. You should see
the following screen:
Section 3: Making Copies from an existing partition/image of the Hard Drive.
Step 1: Use the up or down arrow button to navigate to the Copy menu:
DUPLICATOR 2.20
9.Hard Drive Setup
DUPLICATOR 2.20
7.Select Source
Drive 0 Port x.x
ASUS DVD-E818A
HARD DRVIE Port x.x
HITACHI HDS721616PL
DUPLICATOR 2.20
7.Select Source
DUPLICATOR 2.20
1. COPY