- 48 -
Error Code
Typically the system will show an error message and error code if a problem occurs. Please
reference the below diagram for a description of the error codes and the recommend solution:
Error
Code
Error Message Description & Recommended Solutions
200
Source Disc
Empty
Description:
The intended master disc is detected and identified successfully, but
it is a blank disc.
Possible Solution:
Please double check the master disc to ensure it contains data.
201 Bad Master
Description:
The master disc is detected but can not be identified within 3
minutes.
Possible Solution:
Please check the master disc quality for defects or errors.
202 No Targets!
Description:
The blank disc(s) are missing when the job has already started.
Possible Solution:
Please make sure blank discs are placed in writer trays.
203
Burner Mixed or
Firmware
version Mixed
Description:
The model or firmware version of all writers in the duplicator is not
the same.
Possible Solution:
This typically happens when you recently replaced a writer drive.
Contact Tech Support.
204
Targets &
Master Not
Compatible!
Description:
The master disc and targets (blanks) do not have same format.
Possible Solution:
Please go to “Disc Info” in “Utilities” to make sure the master disc
and the blank discs are the same format, (for example, using a CD
Master and CD blank discs).
205
Targets Not
Blank!
Description:
The target (blank) discs are detected and identified as neither RW
discs nor blank discs.
Possible Solution:
Please go to “Disc Info” in “Utilities” to make sure the intended blank
discs are empty.
To Next Page
Loading...