Copystar LightScribe - Select Partition; Load Partition

To Next Page

To Previous Page

- 12 -

Step2: Press “ENT”/Enter button to enter the Hard Drive Setup menu.

If the current source is not Hard Drive, you will see the screen below. Please press the

“ENT”/Enter button once to proceed.

Once you’ve entered the Hard Drive Setup menu, you will see following screen:

Step3: Use the up or down button to locate the Load Partition menu; as shown in the

reference screen shot below.

Step4: Press the “ENT”/Enter key to enter the Load Partition menu and you should see the

following screen.

You have a choice when loading your master disc content into the hard drive by pressing the

up or down button to find your desired partition naming method:

Option 1:

A new partition/image

Screen Shot (New Partition)

Option 2:

Overwrite one of the existing partitions/images (if any exists, including the reserved

partition/image)

Screen Shot (Overwrite)

Option 3:

Choose Auto Generate to have the system automatically generate a partition/image name

for you.

Screen Shot (Auto Gen)

From 1 of the 3 choices above, press the “ENT”/Enter button to submit your selection.

Hard Drive Setup

1.Select Partition

Hard Drive Setup

2.Load Partition

Select HDD as source

OK?

Load Partition[160GB]

Loa

►New Partition

 160GBindicatesthetotalavailablecapacityof

thesystem’sharddrive–thisnumberwillvary

basedonthesizeoftheharddriveinstalledin

yourduplicator.