- 29 -
Step 3: Once the Mix Mode selection is submitted, you shall see following Preparation
screen and the corresponding trays that do not contain disc(s) in them will
automatically be ejected:
Or
If either one of the above screens is displayed for more than 2 minutes after you
have placed your master disc or blank disc into the drives, please check the disc
quality.
Step 4: After you’ve placed an Audio CD containing the track(s) you wish to copy, and a
blank CD-R media in the writer drive(s), please allow 5-10 seconds for the system to detect
them. After they have been recognized, then you should see the following screen:
Step 5: When you see the above screen shot, you can press the up or down button to
display the playtime of each track on this audio CD and press the “ENT”/Enter button to
select the track you wish to be mixed. Once a track is selected, you shall see the symbol “*”
on the left of the track number on the 2nd line as shown in the below screen.
If the track you have selected will cause the total playtime of all audio tracks to be
more than your blank CD-R media capacity, you should see the following screen.
Preparing
Waiting for Master
Preparing
Waiting for a Blank
Total: 0 Trk 0m: 0s
Track 1: 4m:31s
“Total:0Trk0m:0s”indicatesthatyou havezerotrack(s)
selectedandithaszerominutesandzeroseconds
playtime.
“Track1:4m:31s”indicatescurrentlyyouarefocusingon
trackoneoftheAudioCDyou’veinsertedandhasa
runningtimeoffourminuteandthirty‐one
seconds.
Total: 1 Trk 4m:31s
*Track 1: 4m:31s
Over Blank Disc Capacity
Press OK to Continue
To Next Page
Loading...