18
CRC-6500-S Standard Charger
1. To charge the CORE
TM
Power Cell,
place the charger (1) in a dry
location near a 120 V AC, 60 Hz
electrical outlet and plug it into the
outlet (Fig. 2).
NOTE: The LED will turn green,
indicating that power is actively being
supplied to the charger and that the
charger is ready to charge a Power
Cell. If the LED does NOT turn green,
the charger is not receiving power from
the electrical outlet or the charger is not
functioning properly.
2. Insert the CORE
TM
Power Cell (2)
into the matching cavity (3) in the
top of the charger.
NOTES:
a) Make sure the "TOP" marking (4) on
top of the Power Cell is facing toward
the LED light (5) on the charger.
b) Make sure the Power Cell is pressed
fully into the charger cavity.
3. When the Power Cell is inserted
into the charger, the LED will
change from green to red,
indicating the Power Cell is
properly installed and is being
charged.
4. When the Power Cell is fully
charged, the LED will turn green.
5. When the Power Cell is fully
charged, remove it from the
charger and unplug the charger
from the power source.
ASSEMBLY AND OPERATING
Fig. 2
To Next Page
Loading...
Need help?
General
