ET 66 - ET 66 M operator’s manual
The machine is on, but when the levers are operated the wheel
does not move (only ET66M)
Failure of supply to pneumatic system
➥ Check that there is air in the pneumatic circuit, and that the pressure is correct.
Motor breakdown
➥ Call in CORGHI technical service.
Microswitch incorrectly positioned
➥ Call in CORGHI technical service.
The balancing machine gives non-repetitive unbalance data
The machine was jolted during a spin
➥ Repeat the spin taking care not to jolt the machine during data reading
The machine is not resting stably on the floor
➥ Check that the machine is located stably and shim to level it if necessary
The wheel is not clamped properly
➥ Tighten the spinner properly
Multiple spins are needed to balance a wheel
The machine was jolted during a spin
➥ Repeat the spin taking care not to jolt the machine during data reading
The machine is not resting stably on the floor
➥ Check that the machine is located stably and shim to level it if necessary
The wheel is not clamped properly
➥ Tighten the spinner properly
The wheel data input are incorrect
➥ Enter the correct wheel data
The machine is out of calibration
➥ Perform the calibration procedure
WARNING
The “Spare parts” handbook does not authorise the user to carry out work on the
machine with the exception of those operations explicitly described in the user’s
manual, but enables the user to provide the technical assistance service with
precise information, in order to reduce delay.
Грузик - все для шиномонтажа www.gruzik.com.ua
To Next Page