ET 66 - ET 66 M operator’s manual
GB
SAFETY REGULATIONS
The equipment is intended for professional use only.
WARNING
Failure to observe these instructions and the relative danger warnings can cause
serious injury to the operator and others. Do not power up the machine before you
have read and understood all the danger/warning/attention notices in this manual.
This machine must be used only by qualified and authorised personnel. A qualified
operator is construed as a person who has read and understood the manufacturer’s
instructions, is suitably trained, and is conversant with safety and adjustment proce-
dures to be adhered to during operations. Operators are expressly forbidden from
using the machine under the influence of alcohol or drugs capable of affecting physical
and mental capacity.
The following conditions are essential:
- the operator must be able to read and understand the contents of this manual;
- make sure the operator has a thorough knowledge of the capabilities and characteris-
tics of this machine;
- keep unauthorised persons well clear of the area of operations;
- make sure that the machine has been installed in compliance with established
legislation and standards;
- make sure that all machine operators are suitable trained, that they are capable of
using the machine correctly and that they are adequately supervised during their
work;
- do not touch power lines or the inside of electric motors or other electrical equip-
ment until the power has been disconnected and locked out.
- read this manual carefully and learn how to use the machine correctly and safely;
- always keep this user manual in a place where it can be readily consulted when
working with the machine and consult it whenever you are in need of confirmation or
explanations.
WARNING
Do not remove or deface the safety Danger, Warning or Instruction decals. Replace
any missing or illegible Danger, Warning or Instruction decals. Missing or damaged
decals can be obtained at your nearest Corghi dealer.
- When using and carrying out maintenance on the machine observe the unified
industrial accident prevention regulations for high voltage industrial equipment and
rotating machinery.
- Any unauthorised alterations made to the machine automatically release the manu-
facturer from any liability in the case of damage or incidents attributable to such
alterations. Specifically, tampering with or removing the machine’s safety devices is a
breach of the regulations for industrial accident prevention.
WARNING
When operating or servicing Corghi equipment do not wear ties, loose fitting
clothes, necklaces or wristwatches and any other articles that could become
entrapped by moving parts. Tie back long hair or cover with a scarf or a cap.
Грузик - все для шиномонтажа www.gruzik.com.ua
To Next Page
Loading...