ET 66 - ET 66 M operator’s manual
DEMOLITION
If the machine is to be scrapped, remove all electrical, electronic and plastic compo-
nents and dispose of them separately as provided for by local legislation.
RECOMMENDED FIRE-EXTINGUISHING
DEVICES
When choosing the most suitable fire extinguisher consult the following table:
Dry combustibles Inflammable liquids Electrical fires
Water YES NO NO
Fuam YES YES NO
Dry chemical YES* YES YES
CO
2
YES* YES YES
YES* Use only if more appropriate extinguishers are not on hand and when the fire is small.
WARNING
The indications in this table are of a general nature. They are designed as a
guideline for the user. The applications of each type of extinguisher will be illustrat-
ed fully by the respective manufacturers on request.
GLOSSARY
Balancer FLANGE
Disk that mates with the disk of the wheel mounted to the balancer. The flange also
serves to keep the wheel perfectly perpendicular to its axis of rotation.
BALANCING CYCLE
Sequence of operations performed by the user and the machine, starting from the start
of the wheel spin to the time that the wheel is braked to a standstill after the unbal-
ance signals have been acquired and the relative values calculated.
CENTRING
Procedure for positioning the wheel on the spin shaft with the aim of ensuring that the
rotational axis of the wheel is aligned with the centre of the shaft.
Centring FLANGE (accessory)
Device serving to support and centre the wheel. Also keeps the wheel perfectly
perpendicular to its axis of rotation.
The centring flange is mounted to the balancer shaft by means of its centre hole.
CONE
Conical components with centre hole which, when inserted on the spin shaft, serves to
centre wheels with centre holes whose diameter is between maximum and minimum
values.
DYNAMIC BALANCING
Operation in which unbalance is corrected by the application of two weights, one on
each side of the wheel.
Грузик - все для шиномонтажа www.gruzik.com.ua
To Next Page
Loading...