ET 66 - ET 66 M operator’s manual
GB
- Change the number shown on the right hand display by pressing the and
keys until the correct setting is shown.
- If you hold down the
and keys the numbers will spool up or down
quickly and make data input faster.
Once the wheel data have been input correctly:
- press
to display the unbalance (recalculated for the new wheel data) or
- execute a new spin cycle.
UNBALANCE DISPLAY IN
GRAMS OR OUNCES
Set up the machine for data display in grams or ounces by keeping key pressed
for approximately 5 seconds.
ROUNDING OFF
When the machine is switched on its default setting is for truck wheels. In this mode
unbalance is displayed in units of 50 grams rounded up or down to the multiple of 50
nearest to the actual figure (or in ounces if the default setting has been changed to
this).
When the machine is set up for car wheels, normally the unbalance will be displayed in
units of 5 grams rounded up or down to the multiple of 5 nearest to the real figure (or
in quarter ounces if the default setting has been changed to this).
In these instances the effective threshold is signalled by the “x5” LED lighting up on
the display panel.
Press
to eliminate the threshold (the “x5” LED goes out) and the unbalance
figures are displayed:
- in units of 10 grams (or half ounces) if the machine has been set up for truck wheels;
- in units of 1 gram (or tenths of an ounce) if the machine has been set up for car
wheels.
can be used to toggle between the two display modes.
Грузик - все для шиномонтажа www.gruzik.com.ua
To Next Page