Corghi ET 66 - Page 18

ET 66 - ET 66 M operator’s manual
TRUCK OR CAR WHEEL BALANCING
The machine can handle truck and car wheels. Since the balancing procedure is quite
different for the two types of wheel (e.g. the number of spin revs), the machine should
be set for the type of wheel to be balanced.
- Press the
keys until the LED next to TRUCK or CAR lights.
- Press to confirm your selection.
The LED will stay lit as set and thus tell you at any time what type of wheel the
machine is set up for.
The default setting when the machine is switched on is TRUCK.
WARNING
AS A SAFETY PRECAUTION DO NOT SPIN A TRUCK WHEEL WHEN THE MACHINE
IS SET UP FOR “CAR”
WHEEL DATA INPUT
- Press key .
The machine is ready to receive the WIDTH (the corresponding LED will light)
- Measure rim width with the caliper (fig.10).
- Change the number shown on the right hand display using the keys
until the correct number is set.
WIDTH can be input in millimeters or a previous input can be converted from
millimetres to inches. To do this press ENTER. To return to input in inches press
again.
A LED on the panel will light to identify the current unit of measurement (mm or
inch).
- Press
again to confirm the inpur and to set up the machine for DIAMETER (the
corresponding LED will light).
- Read the rim diameter on the tyre.
- Change the number of the right hand display with the
and keys until
the correct number is shown.
DIAMETER can be input in millimetres or a previous input can be converted into
inches. To do this press ENTER. To return to input in inches press
again.
A LED on the panel will light to show the current unit of measurement (mm or inch).
- Press
a third time to confirm the input and set up the machine for DISTANCE
(the corresponding LED will light).
- Move the distance gauge until it touches the edge of the inside rim channel as shown
in fig.11.
- Read the machine/rim distance on the ruler.
Грузик - все для шиномонтажа www.gruzik.com.ua