ET 66 - ET 66 M operator’s manual
GB
Wheel demounting
- Bring the wheel lift to its fully extended position by pulling the relevant handle
(A, fig.8);
- raise the wheel lift by setting the control lever (B, fig.8) to UP until the lift platform is
in contact with the tyre.
Important
At this point raise the lift platform (C, fig.8) a fraction more so that it takes a little of the
weight of the wheel to adjust for the slight dropping at the time that the wheel is
released from the spin shaft caused by the small amount of give in the pneumatic lift
cylinders.
- Release the wheel by removing the spinner and the counter flange or the cone;
- pull the carriage outward until the wheel is clear of the spin shaft (so that it can be
lowered);
- completely lower the wheel lift using the DOWN control lever;
- roll the wheel off the lift platform;
- push the wheel lift in so that it is properly stowed (home position).
SWITCHING ON THE BALANCER
Turn on the machine with the master switch on the left hand side of the cabinet
(F, fig.4).
After the beep and the lamp test, the machine is ready to receive the wheel data.
Figure 9 shows the display panel with reference letters:
A Inside plane display (left)
B Outside plane display (right)
C Inside plane position indicator
D Outside plane position indicator
E Keys and leds for selecting and displaying available programs
F Key and led for input of wheel data
Грузик - все для шиномонтажа www.gruzik.com.ua
To Next Page