Cornelius Cascata180 - User Manual

Questions and Answers

B
Brandon SnyderAug 4, 2025
What to do if Cornelius Dispenser has excessive coffee temperature?
- L
  lindarodriguezAug 4, 2025
  If your Cornelius Dispenser is dispensing coffee that is too hot, there are several potential causes and solutions: * Ensure the power to the body is turned on. * Reset the overload protector if it has tripped. * If it's a new installation, add more water to the ice-bank. * Check the filter screen for blockages, as overheating of the pre-cooling body can occur. * If it is a fault of the refrigeration system, please contact device servicing personnel.
C
Chad RobersonAug 10, 2025
Why is the coffee flow at outlet small in Cornelius Dispenser?
- J
  Jermaine WallaceAug 11, 2025
  A small coffee flow at the outlet of your Cornelius Dispenser can be due to several reasons: * The coffee keg might not be properly connected to the system. Ensure that the connectors of the nitrogen and liquid pipelines are securely attached to the coffee keg. * The valve nozzle on the tap could be blocked. Try washing the valve nozzle of the tap. * The main valve on the nitrogen cylinder might not be open, or there's no reading on the nitrogen pressure gauge. Open the main valve of the nitrogen cylinder. * If the pressure readings on the gas regulator are lower than the set value, no solution was mentioned.
A
Andrew MeyerAug 16, 2025
What to do if Cornelius Dispenser has insufficient foam in coffee?
- M
  Mrs. Samantha SpencerAug 16, 2025
  If your Cornelius Dispenser is producing coffee with insufficient foam, consider the following: * Address any small coffee flow rate issues first. * Ensure there is a sufficient nitrogen supply by checking that the main valve of the nitrogen cylinder is open and the pressure is adequate. * If the device was recently disinfected, continue dispensing coffee, discarding the first three cups, and observe if the bubbles improve. * If necessary, finely tune the volume of charged nitrogen using the nitrogen infusion rate control valve.
T
tiffany20Aug 22, 2025
Why does Cornelius Dispenser have excessive foam in coffee?
- D
  Daniel DixonAug 23, 2025
  Excessive foam in coffee dispensed from your Cornelius Dispenser can occur for a few reasons: * The coffee keg may have insufficient coffee. Replace it with a filled coffee keg. * If you've just disinfected the device, keep dispensing coffee and observe the bubbles. You may need to discard the first three cups. * The nitrogen infusion rate control valve may need fine-tuning. Adjust the volume of charged nitrogen as needed.
G
Glenn HoodAug 28, 2025
What to do if there is a leakage on the Cornelius Dispenser?
- R
  Rebecca WebbAug 28, 2025
  If you notice a leakage of coffee or nitrogen, or any damage to parts on your Cornelius Dispenser: * Turn off the main power supply. * Close the main nitrogen valve. * Please contact device servicing personnel.