Cornelius IntelliBlue R134 Kuwait Series User Manual (English)

Questions and Answers:

E
Emily SmithAug 8, 2025
Why is the CO2 volume too low in my Cornelius Dispenser beverage?
- G
  Gregory BurnsAug 8, 2025
  Several factors can lead to low CO2 volume in your Cornelius Dispenser beverage. First, ensure there's no air in the carbonator by bleeding any trapped air. Next, reduce the dispense rate if it's at capacity. Check the CO2 cylinder; replace it if empty, and ensure the valve on both the cylinder and pressure regulator are open. Adjust the valve to the correct pressure if the CO2 pressure is too low. Finally, if the water temperature is too high, allow time for a new ice bank to build up.
J
Jerry TranAug 12, 2025
What to do if my Cornelius Dispenser is dispensing foamy beverages at all taps?
- T
  thompsonsharonAug 12, 2025
  If your Cornelius Dispenser is dispensing foamy beverages at all taps, several issues could be the cause. Ensure the CO2 pressure isn't too high by setting it correctly. Check if all syrups are enriched with CO2 and connect a container with fresh product. Verify that all beverages are stored at the correct temperature. Also, note the output capacity, as dispensing too much beverage can cause foaming.
J
jill98Aug 16, 2025
How to fix a Cornelius Dispenser when the beverage is too warm but the compressor is running?
- L
  Laura MyersAug 16, 2025
  If your Cornelius Dispenser is dispensing a beverage that is too warm and the compressor is running, the condenser may be dirty. Use a brush to clean the condenser louvers.
M
morsecrystalAug 20, 2025
What to do if my Cornelius Dispenser tap only outputs concentrate?
- T
  Thomas JuarezAug 20, 2025
  If the Cornelius Dispenser tap is only outputting concentrate, first check if the water feed line is open. Then, check if the water flow pressure is at 2 bar. If the carbonator pump isn't running, contact a service technician.
T
Thomas GrantAug 25, 2025
What to do if my Cornelius Dispenser beverage is too warm and the compressor isn't running?
- B
  blairericAug 26, 2025
  If your Cornelius Dispenser is dispensing a beverage that is too warm and the compressor is not running, the compressor or electric control may be defective. Also, check whether the carbonator motor is running; if not, call service technician. In both cases, it's recommended to call a service technician.
J
Jennifer MartinAug 29, 2025
Why is there too much or not enough syrup in my Cornelius Dispenser beverage?
- D
  Dr. Veronica RodriguezAug 29, 2025
  If your Cornelius Dispenser is dispensing a beverage with too much or not enough syrup, the regulator in the tap might be blocked, or the tap could be misaligned. Additionally, the pressure for the syrup may be too low or too high; adjust the CO2 pressure accordingly. For issues with the regulator or tap alignment, contact a service technician.
R
Ricardo LewisSep 2, 2025
How to stop beverage from foaming at one tap on my Cornelius Dispenser?
- H
  harperbrookeSep 2, 2025
  If a beverage foams at a tap on your Cornelius Dispenser, the syrup may have been stored for too long. Connect the tap with a fresh product.