What to do if my Cornelius Nueva Tower is unable to dispense?
If your Cornelius Dispenser is unable to dispense beverages, ensure that the mains/power supply is correctly connected. Also, check that the tower is switched on by turning the key switch to the “I” position. If these steps don't resolve the issue, there may be a fault or error with the dispensing valve, and you should consult the dispensing valve documentation.
Why is my Cornelius Nueva Tower Dispenser only dispensing soda?
If your Cornelius Dispenser is only dispensing soda, verify that the syrup container is not empty and connect a new one if needed. Check that the connections on the syrup container are properly connected. Ensure the CO feed pressure for the syrup tube is correctly set. Also, check for a contaminated syrup tube and clean it if necessary. If the issue persists, there may be a fault or error on the undercounter cooler or the dispensing valve, and you should consult their respective documentation.
Why does the beverage from my Cornelius Dispenser foam for all products?
If the beverage from your Cornelius Dispenser foams for all products, it could be due to several reasons. The soda water might be too warm, so you should check the undercounter cooler documentation. The CO feed pressure for the soda circuit might be too high, requiring adjustment. If using stainless steel tanks, the syrup might have been stored too long with added CO2, so connect a new syrup container. Finally, contaminated tubes can cause foaming, so clean them.
Why is there an insufficient amount of CO2 in the beverage from my Cornelius Nueva Tower?
If the amount of CO2 in the beverage from your Cornelius Dispenser is insufficient, it could be due to incorrectly set CO pressure for soda. Adjust the CO pressure for soda on the relevant pressure-reducing valve. Another possible cause is a fault or error on the undercounter cooler. Also ensure that the CO supply is not too low by changing the CO bottle.
Why is my Cornelius Dispenser only dispensing syrup?
If your Cornelius Dispenser is only dispensing syrup, check if the shut-off valve or pressure-reducing valve for the fresh water supply is closed, and open them. If the problem continues, there may be a fault or error on the undercounter cooler, and you should consult its documentation.
How to fix incorrect soda/syrup ratio in Cornelius Nueva Tower Dispenser?
If the soda/syrup ratio is incorrect in your Cornelius Dispenser, there may be a fault or error on the dispensing valve, and you should consult its documentation. Another possible cause is the CO feed pressure for the syrup tube being set incorrectly; adjust it to the required value.
Why is the beverage from my Cornelius Nueva Tower Dispenser too warm?
If the beverage from your Cornelius Dispenser is too warm, there may be a fault or error on the undercounter cooler, and you should consult its documentation.
To Next Page
General