2.2.3.1 Use the MULTI-FUNCTION ADJUSTMENT/SELECTION KNOB to
select if you are using a spool gun. Press the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB to confirm your selection.
2.2.3.1.1 No Spool Gun Used:
2.2.3.1.1.1 Connect the Weld Power Cable (See Figure 8
or follow the onscreen visual) to the Positive (+)
Weld Output Connection. Press the
MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB to confirm
your selection.
2.2.3.1.1.2 Use the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB to select
your wire diameter. Press the
MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB to confirm
your selection. (.040 or .045 are ran the same).
Only .045 wire diameter is recommended when
not using a spool gun. To run other wire sizes
of aluminum wire without a spool gun, use the
MIG MANUAL setup.
2.2.3.1.1.3 Use the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB to select
the thickness of material to be welded. Press
the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB to confirm
your selection.
2.2.3.1.1.4 This machine is now set to weld.
2.2.3.1.1.4.1 Use the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB
to fine tune wire feed speed.
2.2.3.1.1.4.2 Use the VOLTAGE CONTROL KNOB
to fine turn voltage.
2.2.3.1.1.5 You can adjust other parameters:
2.2.1.1.5.1 Press the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB.
Wire Speed will no longer be
highlighted but will have a box around
it. Turn the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB
to go through other options. Press the
MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB
to adjust the highlighted Option.
2.2.3.1.2 With a spool gun:
2.2.3.1.2.1 Use the MULTI-FUNCTION
ADJUSTMENT/SELECTION KNOB to select
the wire alloy to be used.
To Next Page
Loading...
