© Corroventa Avfuktning AB
Normally 1. 0 when the alarm occurs – shown
on the panel.
During continuous fan operation 1 otherwise 0
0 for Fixed regulation. 1 for Mould Growth
Index.
Number of months to service. Starts at 13
and counts down.
Logged when time is changed.
Logging of Control Unit's ID.
Logged when the system attempts to connect a
new unit. 0 for Standard, 1 for Service.
Normally 1. 0 when the alarm occurs – shown
on the panel.
Normally 1. 0 when the alarm occurs – shown
on the panel.
Normally 1. 0 when the alarm occurs – shown
on the panel.
Logged when an alarm or
service message is acknowledged.
Logging of control panel version.
0 for Lite. 1 for Pro.
Logging of month's operating hours.
Occurs the last day of each month.
Logging of month's average temperature.
Occurs the last day of each month.
Logging of the month's relative humidity
(RH). Occurs the last day of each month.
Number of operating hours for the day
The day's average temperature
The day's average relative humidity (RF)
Maintenance and service
HomeVision® does not need any regular servicing or maintenance.
The control panel's ability to run on battery power is only intended for use during installation work
and any service work in crawl spaces.
When this has been completed, HomeVision® must be powered by battery eliminator and it is
recommended to remove the batteries because many types and brands have a tendency to leak as
they age. This can, in turn, damage the electronics in HomeVision®.
If for any reason batteries must be replaced, use 1.5V AAA cells. Two batteries are needed.
To Next Page
Loading...