STEP 8 - CHECK OPERATION OF ELECTRONIC
IGNITION SYSTEM
The cooktop and oven burners use electronic igniters in place of standing
pilots. When the cooktop control knob is pressed and turned to the “ ”
position, the system creates a spark to light the burner.
This sparking continues, as long as the control knob is pressed.
When the oven control is pressed and turned to the desired setting, sparking
occurs and ignites the gas.
Check Operation of Standard Surface Burners:
light because of air in the gas line.
If burners do not light properly:
1. Turn burner control knob to the “OFF” position.
2. Check that the range is plugged in. Check that the circuit breaker has not tripped
or the household fuse has not blown.
3.
4. Check that burner caps are properly positioned on burner bases.
Repeat start-up. If a burner does not light at this point, turn the control knobs to
the “OFF” position and contact your dealer or authorized service company for
assistance.
To adjust ame height:
a
b
a Low Flame
b High Flame
To adjust standard burner:
IMPORTANT: Adjustments must be made with two other burners in operation on
stem. The valve stem is located directly behind the control knob.
To Next Page
Loading...
