2. Remove the control knob.
3.
•
•
4. Replace the control knob.
5.
each setting.
6. Repeat above steps for each burner.
STEP 4 - TESTING FLAME STABILITY
Test 1
Test 2 - With the burner on “LO”, open and close the cabinet door under the
STEP 5 - FLAME RE-CHECK
IMPORTANT: Once the conversion has been completed and has passed testing,
conversion is made. Apply the sticker near the cooktop gas inlet opening to alert
others in the future that this appliance has been converted. If converting back to
Natural Gas, please remove the sticker so others know that the appliance is set to
use its original gas.
ABNORMAL OPERATION
ANY OF THE FOLLOWING ARE CONSIDERED TO BE ABNORMAL OPERATION
AND MAY REQUIRE SERVICING:
•
•
Sooting up of cooking utensils.
•
Burners not igniting properly.
•
Burners failing to remain lit.
•
•
IN CASE THE APPLIANCE FAILS TO OPERATE CORRECTLY, CONTACT THE
AUTHORIZED SERVICE PROVIDER IN YOUR AREA
THE BURNERS REQUIRE NO REGULATION OF THE PRIMARY AIR
To Next Page
Loading...
Need help?
General
