Coster YHC 700 - Software Reset; 6 Remote Management; 7 YHC Configuration; Connecting to YHC

YHC 700 6. Remote management
5.12 Software reset
From version 2.0 it is possible to restart the device SW from YHC 700 configuration pages.
This operation can be useful in case of problems or when the YLC baudrate has been
changed after the first configuration (in this case, YHV 700 SW must be restarted to detect the
new baudrate).
6. Remote management
Remote management and supervision through YHC 700 can be carried out in different ways,
depending on the type of system we want to manage/supervise.
Control systems can be:
● remotely managed with ClimaOffice/WEBGarage
● remotely supervised or any software able to:
○ send ModBus commands to read the YLC in field
○ manage the data received from the YHC via HTTP/HTTPs
Monitoring systems can only be supervised, through:
● YHC web pages (see chapter 10)
● WEBGarage or any software able to:
○ send ModBus commands to read the YLCs in field
○ manage the data received from the YHC via HTTP/HTTPs
7. YHC Configuration
YHC 700 can be configured using the HTML pages it provides.
7.1 Connecting to YHC
To configure YHC 700 via HTML pages, first of all you must connect to YHC700 in one of the
following ways:
• Wi-Fi connection (via certified Wi-Fi USB dongle)
• Connection via USB cable
• Connection via Ethernet cable
17