Cotek SE200-124 - Remote Port (RJ-11)

18
EN
Mode 1
Mode 2
Mode 3
Mode 4
Table 18. SE series wiring for control
3-2-3. Remote Port (RJ-11) 
The SE400 inverter can be compatible with CR-8 remote control.
Before using the remote control, make sure the main switch on
inverter must be at “ REMOTE” position.
Pin Number
Signal Description
1
Reserved
─
2
GND
The same polarity as the battery negative
side
3
─
─
4
─
─
5
RMT
Remote controller panel (positive)
6
─
─
Table 19. SE series green terminal signal description