COTES LIGHTWEIGHT - USER MANUAL
NOTE
Make sure power is switched off before installing and servicing.
Power connection
First, make sure that the selector switch is in position 0. Now the power cable can be connected to the mains.
Cotes Lightweight dehumidifiers are suitable for 230V-50Hz, 1PH+N+PE power supply.
The dehumidifier is supplied with build in socket for different cable length and plug for the power supply.
Connect this cable to the left socket (Power) on the control panel.
Hygrostat connection
The dehumidifier is prepared to be regulated by an external hygrostat. See appendix 2 for available options.
Set the hygrostat to the desired humidity level. The dehumidifier will start, when the humidity is above the
selected level. The hygrostat cable is connected to the right socket (Hygrostat) on the control panel.
When using a hygrostat to control the dehumidifier, adjust the selector switch accordingly. See section 5.2.
Ductwork
NOTE
To ensure low pressure drop and low sound pressure levels, request
assistance from a company that specialises in ventilation systems.
In general, ducts of the same size or larger as those placed on the dehumidifier should be used.
• The regeneration outlet is designed with a Ø80 mm female connection.
• The process air outlet (dry air) is designed with a Ø125 mm female connection.
NOTE
The regeneration air outlet duct should be directed at least a few degrees
downwards to allow for drainage of the condensed water.
If this is not possible, drill a Ø6mm hole in the lowest part of the duct.
To Next Page
