SINGLE SIDE BAND (SSB)
1. In any mode, press the [USB/LSB] button to select SSB
reception; press again to select USB/LSB.
2. Turn the [TUNING] knob to search stored SSB stations.
3. Press the [BFO] button, when “U” / “L” flashes on the display,
turn the [TUNING] knob to adjust the reception.
When it is off, press and hold the [BFO] button to set the fine
tuning step. (P.15)
Exit SSB Mode: Press and hold the [USB/LSB] button to exit.
WORKING WITH MEMORIES
There are total 550 preset memories within radio. For FM, MW and SSB, each band has 100
preset memories; and 250 preset memories for SW.
Method 1: ATS - Auto Tuning Storage Turn on the radio and
elect the band that you want to ATS to take place in, either FM or
MW.
Long press the [FM] or [MW] button and notice that the
" PRESET" number (001) appears in the display's upper right
corner with the presets to the right increasing as the band is
scanned and frequencies are stored into memory.
There are two modes for SW ATS function:
Mode A: In SW band, long press the [A / ] button to ATS the
stations within all meter bands.
Mode B: In SW band, long press the [B / ] button to ATS the stations within present meter
band only.
Note:
During ATS process in FM, MW or SW (mode A), pre-stored radio stations will be replaced
automatically by the new searched stations.
With ATS in SW (mode B), those existing memories will not be replaced; all the newly found
radio stations would be stored in the blank memories addresses.
Method 2: MANUALLY STORING STATION
1. Tune to your desired station, press the [MEM.] button once and notice the PRESET number
flashing in the upper right corner of the display.
2. While it flashing, press the [MEM.] button to store it into the memory or wait for 3 seconds to
store it automatically. If you want to store it into another PRESET memory, just rotate the
tuning knob of your choice, and press the [M] button to confirm.
To Next Page
Loading...