EasyManua.ls Logo

CountyLine CLTS25P - User Manual

CountyLine CLTS25P
16 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
1569 0195 GEN
OWNER’S MANUAL
Submersible Sump Pump
MANUAL DEL USUARIO
Bomba sumergible para
sumideros
CLTS25P, CLTS33P
©2017 CL875 (Rev. 01/03/17)
Installation/Operation/Parts
For further operating, installation, or
maintenance assistance:
Call 800-535-4950
English.................Pages 2-7
Instalación/Operación/Piezas
Para mayor información sobre
el funcionamiento, instalación o
mantenimiento de la bomba:
Llame al 800-535-4950
Español ............. Páginas 8-13
293 Wright Street, Delavan, WI 53115
Phone: 800-535-4950
Fax: 800-526-3757
www.tractorsupply.com

Table of Contents

Questions and Answers

  • K
    Kim KirbyAug 6, 2025
    Why CountyLine CLTS25P won't start?
    • L
      Leon ComptonAug 6, 2025
      If your CountyLine Water Pump won't start, there are several potential causes: * The pump may not be plugged into a proper outlet. Check the connection. * A fuse might be blown, or a breaker tripped. Replace the fuse with one of the correct size or reset the breaker. * The line voltage could be low. Inspect the wiring from the main switch; if it's okay, contact the power company. * The motor or float switch could be defective, in which case you should replace them. * The impeller might be obstructed. Remove the lower pump body to find and eliminate any obstructions. * The float itself may be obstructed. Remove the obstruction.
  • J
    Jaime WestAug 22, 2025
    How to fix CountyLine Water Pump that won't shut off?
    • J
      Jennifer WallaceAug 22, 2025
      If your CountyLine Water Pump won't shut off, consider the following: * The float switch may be defective. Replace it. * There might be a restriction in the discharge, such as an obstacle or ice in the piping. Remove the pump and clean both the pump and the piping. * The float could be obstructed. Clear any obstructions. * The intake screen might be restricted. Remove the pump and clean both the intake screen and the impeller.
  • T
    Tricia NicholsonAug 29, 2025
    Why CountyLine Water Pump starts and stops too often?
    • S
      shawadrianAug 29, 2025
      If your CountyLine Water Pump starts and stops too often, the following reasons may apply: * Backflow of water from the piping. Install or replace the check-valve. * Faulty float switch. Replace the float switch.
  • N
    Nicole MeltonNov 12, 2025
    What to do if CountyLine Water Pump delivers little or no water?
    • S
      Steven LawsonNov 13, 2025
      If your CountyLine Water Pump runs but isn't delivering enough water, consider these possibilities: * Low line voltage could be the issue. Check the wiring from the main switch; if the wiring is adequate, contact your power company. * There might be something caught in the impeller. Remove the pump and clean the impeller. * The impeller could be plugged, or parts may be worn or defective. Try cleaning the impeller; if that doesn't work, replace the pump. * The check valve might be installed without a vent hole. Drill a 1/16” - 1/8” (1.6mm - 3.2mm) diameter hole between the pump discharge and check valve, 1-2” above where the discharge pipe screws into the pump discharge and below the waterline. * The intake screen could be restricted. Remove the pump and clean the intake screen....

Summary

Submersible Sump Pump Owners Manual

Safety

Important Safety Instructions

Crucial instructions for safe installation, operation, and maintenance.

California Proposition 65 Warning

Warning about chemicals linked to cancer and birth defects.

Specifications

Technical details including power, temperature, and circuit requirements.

Warranty

Limited Warranty

Details the 12-month warranty period and conditions for repair or replacement.

Warranty Exceptions

Lists products with shorter warranty periods than the standard 12 months.

Terms and Limitations

Outlines warranty exclusions, remedies, and legal rights.

Installation Guide

Sump Pit Requirements

Details on sump pit diameter, depth, and construction materials.

Discharge Plumbing

Instructions for connecting discharge pipes, including warnings.

Power Supply and Pre-Operation Checks

Connecting power, performing operational checks, and float switch setup.

Operation

Pump Operation Basics

Ensuring submersion for lubrication and avoiding dry running.

Automatic Reset and Cycling

Understanding the thermal protector and causes of pump cycling.

Manual Operation and Prime

Procedure for stopping pump when no water is present.

Troubleshooting Guide

Pump Wont Start or Run

Diagnosing issues like no power, blown fuse, or motor defects.

Pump Starts and Stops Too Often

Troubleshooting rapid cycling due to float switch or obstructions.

Pump Wont Shut Off

Identifying causes like obstructed floats or discharge lines.

Low Water Output

Checking intake screens, impellers, and check valve installation.

Repair Parts List

Parts Identification

Diagram showing pump components and their reference numbers.

Parts Availability

Table listing part numbers for CLTS25P and CLTS33P models.

CountyLine CLTS25P Specifications

General IconGeneral
TypeTrash Pump
Horsepower2.5 HP
Max Flow Rate158 GPM
Discharge Size2 in
Fuel TypeGasoline
Inlet Size2 in
Outlet Size2 in
Engine Type4-stroke

Related product manuals