28 February 2017 Operation and Maintenance
CY460_Operational_Manual_405 Page 124 of 218
Configuration Menu
The Configuration Menu appears below:
"Configuration Menu "
"Changeover = Primary"
"LCD Brightness = 48%"
"LCD Flash on Error= xxx"
"LCD Animation = xxx"
"LCD Timecode = xxx"
"AES1-8 + Analog = Composite1"
"Pulse 1 = xxxxx"
"Pulse 2 = xxxxx"
"Pulse 3 = xxxxx"
"10MHz Mode= xxx"
"Balanced Pins 3+ 4- = xxxx"
"Balanced Pins 5+ 6- = xxxx"
"Balanced Pins 7+ 8- = xxxx"
"Balanced Pins 9+ 10- = xxxx"
"Balanced Pins 11+ 12- = xxxx"
"Balanced Pins 13+ 14- = xxxx"
"Balanced Pins 15+ 16- = xxxx"
"Balanced Pins 17+ 18- = xxxx"
"-Balanced Pins 19+ 20- = AES2"
"-Balanced Pins 21+ 22- = AES1"
"-Balanced Pins 23+ 24- = DARS”
The Configuration Menu provides access to a range of features that determine the functionality of the
CY460 SPG not otherwise covered by other menu settings. These options are typically set up during
the system commissioning of the CY460 SPG, and thereafter are unlikely to be changed.
Definition for:
"Changeover = Primary"
The options in the sub-field appear as:
Primary
Backup
The CY460 SPG can be installed with a partner CY460 SPG and a CY465 Changeover unit.
In this configuration, one of the CY460 SPGs is defined as PRIMARY and the other as
BACKUP. This menu row item allows the selection of PRIMARY or BACKUP. The
polarity of the ONAIR tally is also controlled by this selection.
Definition for:
"LCD Brightness = 48%"
This menu row allows the user to select the best LCD display parameters for the ambient
lighting conditions.
The options are:
0% through 100% in 16 steps.
To Next Page