28 February 2017 Appendices
CY460_Operational_Manual_405 Page 147 of 218
Appendix A : Specifications
This section lists the electrical, mechanical, and environmental characteristics, as well as the national
and international standards to which the CY460 Sync Pulse and Test Pattern Generator complies.
General Characteristics
All listed specifications are guaranteed unless labelled with “Typical”. Typical specifications are
provided for your convenience, but are not guaranteed.
Performance Conditions
The electrical characteristics listed on the following pages are valid under the following conditions:
The CY460 Sync Pulse and Test Pattern Generator must be in an environment where the
temperature, altitude, humidity, and vibration conditions are within the operating limits
described in Table A.34.
The CY460 Sync Pulse and Test Pattern Generator must have a warm-up period of at least 20
minutes.
The CY460 Sync Pulse and Test Pattern Generator must have been calibrated and adjusted at
an ambient temperature between +20 °C and +30 °C at an altitude of less than 2000m.
The following label is used to indicate the altitude limitation.
To Next Page