28 February 2017 Installation and Planning
CY460_Operational_Manual_405 Page 36 of 218
System Functions
From the Top Level menu:
1. Select < –System Setup >.
2. Select < –Temp Report >.
3. This screen displays the current temperatures of any installed sensors.
4. Return to the System Setup menu using the [ Back ] button.
5. Select < –Event Report >.
6. This screen displays the latest reported system events.
7. Return to the System Setup menu using the [ Back ] button.
8. Select < –System Report >.
9. This menu screen reports the various system version numbers.
10. Return to the System Setup menu using the [ Back ] button.
11. Select < –GPS Report >.
12. This menu screen reports the status of the GPS receiver sub-system.
13. Return to the System Setup menu using the [ Back ] button.
14. Select < Configuration >.
15. Select < Changeover > to define whether the SPG is the Primary or the Backup unit
in a changeover pair.
16. Select < LCD Brightness > to select the brightness of the LCD screen.
17. Select < AES1-8 + Analog > to select the reference source for the AES and Analogue
audios.
18. Select < AES7 Output is > to select AES channel 7 or LTC channel 3 to appear on
the relevant pin(s) of the multiway connector on the multifunction sub-module.
19. Select < AES8 Output is > to select AES channel 8 or LTC channel 4 to appear on
the relevant pin(s) of the multiway connector on the multifunction sub-module.
20. Select < Pulse 1 > to select a pulse type to appear at the relevant rear panel BNC of
the multifunction sub-module.
21. Repeat with < Pulse 2 > and < Pulse 3 >to select pulse types at the relevant rear panel
BNCs of the multifunction sub-module.
22. Select < 10MHz Mode > to select the source of a 10MHz reference.
23. Return to the Top Level menu using the [ Back ] button.
Network Settings
The Network Menu can be reached via the < –System Setup > menu option.
Many of the parameters that can be configured in this menu require the operator to obtain
details from a Network Administrator. Once configured, they are unlikely to change.
Changes to this menu are likely to occur very rarely, and so no formal description will be
outlined here. For the purposes of this functional check, simply scroll through the menu (and
sub-menus) to check for any corrupted entries. Refer to the relevant pages in Section 3.6 :
System Setup Menu for details of the various options.
Option Enable Settings
The Option Enable Menu can be reached via the < –System Setup > menu option.
This menu screen lists the installed Option Keys for enabled options within the CY460 SPG.
Changes to this menu are extremely unlikely to occur, and so no formal description will be
outlined here. For the purposes of this functional check, simply scroll through the menu to
check for any corrupted entries. Refer to the relevant pages in Section 3.6 : System Setup
Menu for details of the various options.
To Next Page