2.14.4.1.2 Date and Time
The interface is shown as in Figure 2-132
Date format: There are three types: YYYYY-MM-DD: MM-DD-YYYYY or DD-MM-YYYY.
Date separator: There are three denotations to separate date: dot, beeline and solidus.
DST: Here you can set DST time and date. Here you can set start time and end time by
setting corresponding week setup or by setting corresponding date setup.
NTP: It is to set NTP server information.
Figure 2-132
2.14.4.1.3 Holiday
Holiday setup interface is shown as in Figure 2-133. Click Add new holiday button, you can
input new holiday information. See Figure 2-134. Here you can set holiday name, repeat
mode and start/end time.
Note
When you enable Holiday settings and schedule setup at the same time, holiday setting
has the priority. If the selected day is a holiday, then system records as you set in holiday
setting. If it is not a holiday, system records as you set in Schedule interface. Please note
Please note, there is no year setup on the holiday setup. For example, if you set 30th Oct,
2016 as a holiday, then the date of 30th Oct in each year will be set as a holiday.
To Next Page
Loading...
