Note:
System cannot open config backup interface again if there is backup operation in the process.
System refreshes device when you go to the config backup every time and set current
directory as the root directory of the peripheral device.
If you go to the configuration backup interface first and then insert the peripheral device,
please click Refresh button to view the newly added device.
Figure 2-152
2.14.4.9 Default
Click default icon, system pops up a dialogue box. You can highlight to restore default
factory setup. See Figure 2-153.
Camera
Network
Event
Storage
System
Please highlight icon to select the corresponding function. Click factory default button, you can
restore factory default setup. After all the setups please click save button, system goes back
to the previous menu.
To Next Page
Loading...
