2.13.3.2 Network Load
Network load is shown as in Figure 2-77. Here you can view the follow statistics of the device
network adapter. Here you can view information of all connected network adapters. The
connection status is shown as offline if connection is disconnected. Click one network
adapter, you can view the flow statistics such as send rate and receive rate at the top panel.
Figure 2-77
2.13.3.3 Network Test
Network test interface is shown as in Figure 2-78.
Destination IP: Please input valid IPV4 address or domain name.
Test: Click it to test the connection with the destination IP address. The test results can
display average delay and packet loss rate and you can also view the network status as
OK, bad, no connection etc.
Network Sniffer backup: Please insert USB2.0 device and click the Refresh button,
you can view the device on the following column. You can use the dropdown list to
select peripheral device. Click Browse button to select the snap path. The steps here are
same as preview backup operation.
You can view all connected network adapter names (including Ethernet, PPPoE, WIFI, and 3G), you
can click the button on the right panel to begin Sniffer. Click the grey stop button to
stop. Please note system cannot Sniffer several network adapters at the same time.
To Next Page
Loading...
