is not for video loss or the tampering. There are two ways for you to set periods. Please
note system only supports 6 periods in one day.
In Figure 2-99, Select icon of several dates, all checked items can be edited together. Now
the icon is shown as . Click to delete a record type from one period.
In Figure 2-100.. Click button after one date or a holiday, you can see an
interface shown as in Figure 2-1. There are four record types: regular, motion detection
(MD), Alarm, MD & alarm.
Alarm output: when an alarm occurs, system enables peripheral alarm devices.
Latch: when motion detection complete, system auto delays detecting for a specified time.
The value ranges from 1-300(Unit: second)
Show message: System can pop up a message to alarm you in the local host screen if
you enabled this function.
Alarm upload: System can upload the alarm signal to the network (including alarm
centre) if you enabled current function.
Send email: System can send out email to alert you when an alarm occurs.
Record channel: System auto activates motion detection channel(s) to record once an
alarm occurs. Please make sure you have set MD record in Schedule interface(Main
Menu Setting
Schedule) and schedule record in manual record interface(Main Menu Advanced
Manual Record)
PTZ activation: Here you can set PTZ movement when an alarm occurs. Such as go to
preset, tour &pattern when there is an alarm. Click “select” button, you can see an
interface is shown as in Figure 2-98.
Record Delay: System can delay the record for specified time after alarm ended. The value
ranges from 10s to 300s.
Tour: Here you can enable tour function when alarm occurs. System one-window tour.
Snapshot: You can enable this function to snapshot image when a motion detect alarm occurs.
Video matrix: Check the box here to enable this function. When an alarm occurs, SPOT
OUT port displays device video output. It displays video (1-window tour) from alarm
activation channel you select at the Record channel item.
Buzzer: Highlight the icon to enable this function. The buzzer beeps when alarm occurs.
Log: Check the box here, system can record motion detect log.
Test: Click it to test current motion detect setup (do not need to save). Click Select button
after Region, you can set motion detect area.
Voice prompts: Check the box here to trigger audio broadcast function. You can select
specified audio file here. System can play the audio file once the corresponding event
occurs.
Please highlight icon to select the corresponding function. After all the setups please
click save button, system goes back to the previous menu.
Note:
In motion detection mode, you cannot use copy/paste to set channel setup since the video in
each channel may not be the same.
To Next Page
Loading...
