Motion detect here only has relationship with the sensitivity and region setup. It has no
relationship with other setups.
2.14.2.1.2 Video Loss
In Figure 2-101, select video loss from the type list. You can see the interface is shown as in
Figure 2-101. This function allows you to be informed when video loss phenomenon
occurred. You can enable alarm output channel and then enable show message function.
Tips:
You can enable preset/tour/pattern activation operation when video loss occurs. Please
refer to chapter 2.12.2.1.1 motion detection for detailed information.
Figure 2-101
2.14.2.2 Alarm
Before operation, please make sure you have properly connected alarm devices such as
buzzer. In the main menu, from Setting Event Alarm, you can see alarm setup interface.
For analog channel. For HDCVI channel, there are three alarm types. See Figure 2-102.. For
digital channel, there are four alarm types. See Figure 2-102 to Figure 2-107.
HDCVI: System can get the camera temperature, smoke, external alarm and set
corresponding alarm activation operation.
IPC external alarm: It is the on-off alarm signal from the front-end device and can activate
the local HDVR.
To Next Page
Loading...
