Cradlepoint MBR1400 - Page 202

CRADLEPOINT MBR1400 | USER MANUAL – Firmware version 5.0
© 2013 CRADLEPOINT, INC. PLEASE VISIT HTTP://KNOWLEDGEBASE.CRADLEPOINT.COM/ FOR MORE HELP AND RESOURCES PAGE 200
7.10.7 Global VPN Settings
These settings apply to all configured VPN tunnels.
Enable Certificate Support: Enabling Certificate Support will allow you to load a certificate for VPN to the router. Click the
“Upload Certificate” button that appears to browse for a certificate on a local device. Disabling certificate support will no
longer use any previously loaded certificate but will not delete it from the router. Only one certificate at a time is supported.
IKE / ISAKMP Port: Internet Key Exchange / Internet Security Association and Key Management Protocol port. Default:
500. This is a standard VPN port that usually does not need to be changed.
IKE / ISAKMP NAT-T Port: Internet Key Exchange / Internet Security Association and Key Management Protocol network
address translation traversal port. Default: 4500. This is a standard VPN NAT-T port that usually does not need to be
changed.
NAT-T KeepAlive Interval: Default: 20 seconds. Range: 0-3600 seconds. 20 seconds will be sufficient in almost all
cases.