Craftex CX200 - Setup; Un-Packing & Inventory

8
SETUP
Before setting up your machine you should
read and understand the instructions given
in this manual.
The unpainted surfaces of this table saw
are coated with a rust preventive waxy oil
and you will want to remove this before you
begin assembly. Use a solvent cleaner that
will not damage painted surfaces.
UNPACKING
The machine is properly packaged and
shipped completely in crates for safe
transportation. When unpacking, carefully
inspect the crates and ensure that nothing
has been damaged during transit. Open the
crates and check that the machine and the
parts are in good condition.
Figure-1 Inverntory
LIST OF CONTENST QTY
A. Table Saw........................................ 1
B. Extension Wings .............................. 2
C. Cabinet Door.................................... 1
D. Fence............................................... 1
E. Fence Rails & Tube ......................... 3
F. 10” Blade ......................................... 1
G. Magnetic Switch............................... 1
Figure-2 Inventory
LIST OF CONTENTS QTY
H. Table Insert...................................... 1
I. Blade Guard & Spreader.................. 1
J. Push Stick........................................ 1
K. Miter Gauge..................................... 1
L. Riving Knife...................................... 1
M. Hand Wheel..................................... 2
N. Hand Wheel Lock............................. 2
O. Hand Wheel Handle......................... 2
P. Dust Port.......................................... 1
Q. Hardware Bag.................................. 1
R. Fence Rail Tape Scale..................... 1
WARNING
CX200/CX201 is a very heavy machine,
do not over-exert yourself. For safe
moving method use fork truck or get the
help of an assistant or friend.