To Next PageTo Next Page
Need help?Do you have a question about the Craftsman 113.213130 and is the answer not in the manual?
General| Model Number | 113.213130 |
|---|---|
| Category | Power Tool |
| Type | Table Saw |
| Blade Diameter | 10 inches |
| No-Load Speed | 3450 RPM |
| Max Cut Depth at 90° | 3-1/8 inches |
| Rip Capacity | 24 inches |
Controls belt tension by turning handle clockwise or counterclockwise.
Locks motor bracket support and belt tension handle for correct belt distance and tension.
Locks the head to the column, must be locked while operating.
Locks table support to column, must be locked while operating.
Used to elevate table; support lock must be released first.
Locks the table in any position from 0-45 degrees.
Allows table rotation in various positions and locking.
Moves the chuck up or down; can be removed if interfering.
Holds drill bit or other accessory for desired operations.
Shows degree table is tilted for bevel operations.
Provides means to adjust quill spring tension.
Allows operator to adjust drill press to drill to a desired depth.
Turns drill press on and off; also locks in off position.
Used to tighten drill in chuck and loosen for removal.
Locks the depth scale at selected depth.
Attaches the table to the table support using the table lock.
Mounts the head assembly onto the column tube and secures it.
Secures the motor to the motor bracket using bolts, washers, and nuts.
Slides the motor pulley onto the motor shaft and tightens the set screw.
Aligns pulleys, installs belt, and adjusts tension using handles.
Attaches the belt guard knob to the belt guard using a screw.
Connects the power cord wires to the motor terminals.
Screws feed handles into the threaded holes in the hub.
Cleans spindle and chuck, then installs chuck onto spindle.
Positions the table to desired angles using the bevel scale.
Adjusts the tension of the feed spring.
Provides means to adjust quill spring tension.
Turns drill press on and off, and locks in the off position.
Covers pulleys and belt during operation.
Locks motor bracket support and tension handle.
Applies or releases tension to the belt.
Locks the head to the column.
Moves the chuck up or down.
Holds the rack to the column for table movement.
Rides on column to support arm and table.
Turns clockwise to elevate table.
Provides table elevation via hand-operated table crank.
Supports Drill Press; has holes for bolting to floor.
Supports column, guides rack, and mounts column to base.
Connects head, table, base on one-piece tube.
Provides working surface to support workpiece.
Shows depth of hole being drilled.
Indicates drilling depth selected on depth scale.
Locks the depth scale at selected depth.
Extends beyond table support for mounting and aligning table.
Locks the table in any position from 0-45.
Table can be rotated in various positions and locked.
Shows degree table is tilted for bevel operations.
Locks table support to column.
Holds drill bit or other accessory for desired operations.
Self-ejecting key to tighten/loosen chuck; prevents throwing.
Changed by belt placement on pulleys; see chart inside belt guard.
Drills to a marked depth by setting the depth scale.
Sets the desired drilling depth by positioning the chuck and locking the scale.
Covers personal protection, workpiece handling, and accessory use.
Details how to insert and tighten drill bits in the chuck.
Making a dent using a center punch or nail for precise hole starting.
Describes how to apply feed pressure for optimal cutting and chip removal.
Details steps to adjust quill return spring tension.
Explains lubrication requirements for gears, rack, splines, and quill.
