16. TURN THE SAW OFFAND
UNPLUG THE CORD ifthe blade
bindsin the saw kerrwhile being
backed out ofthe workpiece,
usuallycaused bysawdust
cloggingthe kerr. Ifthishappens,
turnoffthe scrollsaw and unplug
the power cord. Wedge open the
kerf and back the blade out of the
workpiece.
17. DO NOT feed the material too
fast whilecutting. Only feed the
workpiece at the rate the saw will
cut.
18. TURN THE POWER OFF, remove
the switch key and make sure the
scrollsaw comes to a complete
stop before installingor removing
an accessory, and before leaving
the work area.
22.
23.
24.
25.
ALWAYS release blade tension
before looseningthe blade holder
screw,
MAKE CERTAIN table tilting lock
istightened before starting the
machine.
NEVERREACHunderthe scroll
sawtablewhenmotorisrunning.
CHECKFOR DAMAGEDPARTS
beforeeach use.Check for
alignmentof movingparts, binding
ofmoving parts,breakageofparts,
mountingorany otherconditions
thatmayaffectoperation.Partsthat
are damagedshouldbe properly
repairedorreplacedbeforeusing
thetool.
26. THINK SAFE'rY.
19. DO NOT START the saw with
workpiece pressing against the
blade. Slowlyfeed theworkpiece
intothe moving blade.
20. WHEN CUTTING a large
workpiece, MAKE SURE the
material issupported at table
height.
21. EXERCISE CAUTION when
cuttingworkpieces that are round
or irregularlyshaped. Round items
willroll and irregularlyshaped
workpieces can pinchthe blade.
9 !1!11
To Next Page