READ AND UNDERSTAND all
safety instructions and operating
proceduresthroughoutthe manual.
DO NOT OPERATE the Scroll Saw
until it is completely assembled
and installed according to the
instructions.
3. SHOULDany partof ScrollSaw
be missing,damaged,or fail in any
way,oranyelectricalcomponent
failto performproperly,shutoffthe
switchand removethe plugfrom
thepowersupplyoutlet.Replace
missing,damaged,orfailed parts
beforeresumingoperation.
.
.
g.
10.
YOUR SCROLL SAW MUST
BE SECURELY FASTENED to
a stand or workbench. Ifthere
is any tendency for the stand
or workbenchto move during
operation,the stand or workbench
MUST be fastened to the floor.
THIS SCROLL SAW is intended for
indoor use only.
TENSION BLADE PROPERLY
before starting the saw. Recheck
and adjusttension as needed.
BI_ADETEETH MUST POINT
downwardtoward the table.
IF YOU ARE NOT thoroughly
familiar with the operation of a
Scroll Saw, obtain advice from
yoursupervisor,instructoror other
qualified person.
11. TABLE MUST BE CLEARED of all
debris before operating saw. Do not
perform lay out, set up or assemble
work on the table when the saw is
in operation.
SERIOUSINJURYcouldoccur if
the tool tipsoveror youaccidentally
hitthe cuttingtool.Do notstore
anythingaboveor nearthe tool.
6. AVOID INJURY from unexpected
saw movement.Place the saw on
a firm level surface where the saw
does not rock and bolt or clamp the
saw to its support.
12.
13.
14.
TO PREVENT INJURIES,avoid
awkwardhandorfinger positions,
wherea suddenslip couldcausea
handtomove intothebladewhen
operatingthesaw.
HOLD WORKPIECE FIRMLY
againstthe table top.
NEVERCUT MATERIALthat is too
smallto be held safely.
15. DO NOT USEdull or bent blades.
To Next Page
Loading...
