Craftsman 137.284630 User Manual

Operator's Manual
10 iN. JOBSITE TABLE SAW
Model No. 137.284630
C US
CAUTION:
Before using this Table Saw,
read this manual and follow
all its Safety Rules and
Operating Instructions
® Safety Instructions
® Installation
® Operation
® Maintenance
® Parts List
Customer Help Line
For Technical Support
1-800-843-1682
Sears Parts &
Repair Center
1-800-488-1222
Sears Brands Management Corporation Hoffman Estates, IL 60179 USA
See the full line of Craftsman ®products at craftsman.corn
Click on the Craftsman Club_R_link and join today!
Part No. 137284630001 Printed in China

Craftsman 137.284630 Specifications

General

Brand	Craftsman
Model	137.284630
Category	Saw
Language	English

Summary

WARRANTY

CRAFTSMAN FULL WARRANTY

Details Craftsman's full warranty policy for defects in material or workmanship.

PRODUCT SPECIFICATIONS

POWER TOOL SAFETY

GENERAL SAFETY INSTRUCTIONS

General safety guidelines before operating the power tool.

TABLE SAW SAFETY

Guard and Riving Knife Usage

Instructions on using blade guard, riving knife, and anti-kickback pawls.

Workpiece Handling and Kickback Avoidance

Guidelines for secure workpiece handling and preventing kickback.

ELECTRICAL REQUIREMENTS AND SAFETY

POWER SUPPLY AND MOTOR SPECIFICATIONS

Details electrical power requirements and motor specs.

GROUNDING INSTRUCTIONS

ASSEMBLY AND ADJUSTMENTS

ASSEMBLING THE ROLLER WHEELS AND HANDLES TO STAND

ASSEMBLING TABLE SAW TO STAND

SETTING UP THE STAND

INSTALLING THE BLADE

RIVING KNIFE ASSEMBLY

Installing the riving knife assembly

Detailed steps for installing the riving knife assembly.

BLADE GUARD ASSEMBLY

Installing the blade guard and anti-kickback pawl assembly

Steps to install the blade guard and anti-kickback pawls.

AVOIDING KICKBACKS

RIP FENCE ADJUSTMENT

ADJUSTING THE MITER GAUGE

REMOVING THE BLADE

ADJUSTING THE 90° AND 45° POSITIVE STOPS

BLADE PARALLEL TO THE MITER GAUGE GROOVE

OPERATION

RAISE THE BLADE

TILTING THE BLADE

ON/OFF SWITCH

OVERLOAD PROTECTION

CUTTING OPERATIONS

Ripping

Explains ripping, a basic cutting operation.

Crosscutting

Explains crosscutting, another basic cutting operation.

BEVEL RIPPING

Ripping Small Pieces

CROSSCUTTING

BEVEL CROSSCUTTING

COMPOUND MITER CROSSCUTTING

MITERING

NON-THROUGH CUT

DADO CUTS

MAINTENANCE

GENERAL MAINTENANCE

BLADE RAISING AND TILTING MECHANISM

REPLACING THE CARBON BRUSHES

TROUBLESHOOTING GUIDE

Saw will not start.

Does not make accurate 45° and 90° rip cuts.

Material pinched when ripping.

Material binds on riving knife.

Saw makes unsatisfactory cuts.

Material kicked back from blade.

Blade does not raise or tilt freely.

Blade does not come up to speed. Reset trips too easily.

Machine vibrates excessively.

Does not make accurate 45° and 90° crosscuts.