FEATHERBOARD- Whenripping
aworkpieceonyourtablesaw,this
keepsitfirmlyandsafelyagainstthe
ripfence.Italsohelpspreventchatter,
gouging,anddangerouskickback.
REVOLUTIONSPER MINUTE (RPM)
- The number of turns completed by a
spinning object in one minute.
RIP FENCE - A guide used for rip
cutting which allows the workpiece to
cut straight.
RIPPING - Cutting with the grain of
the wood or along the length of the
workpiece.
RIVING KNIFE - A metal piece of the
guard assembly located behind and
moves with the blade. Slightly thinner
than the saw blade, it helps keep the
kerf open and prevents kickback.
SAW BLADE PATH - The area of the
workpiece or table top directly in line
with the travel of the blade or the part
of the workpiece that will be cut.
SET - The distance between two saw
blade tips, bent outward in opposite
directions to each other. The further
apart the tips are, the greater the set.
TABLE INSERT - Insert that is
removed from the table to install/
remove blades. It is also removed for
dado cutting. When dado cutting, a
dado insert plate must be used.
THROUGH SAWING - Making a cut
completely through the length or width
of a workpiece.
WORKPIECE - Material to be cut.
Leadinc
Saw blade path
Workpiece
Trailing
edge
17
To Next Page
Loading...
Need help?
General