Craftsman 31AM2T6D799

Questions and Answers

M
Megan KellyAug 12, 2025
Why won't my Craftsman 31AM2T6D799 engine start?
- P
  Paul RodriguezAug 12, 2025
  There are several reasons why your Craftsman Snow Blower engine might fail to start: * The fuel tank may be empty or contain stale fuel. If this is the case, fill the tank with clean, fresh gasoline. * The key may not be fully inserted. Ensure the key is inserted all the way. * The spark plug wire could be disconnected; connect the wire to the spark plug. * The spark plug may be faulty. Try cleaning it, readjusting the gap, or replacing it altogether. * The engine may not be primed. Push the engine primer button five to seven times. * The engine may be flooded from excessive priming. Wait at least ten minutes before attempting to start it again.
J
James FletcherAug 18, 2025
What to do if my Craftsman 31AM2T6D799 Snow Blower loses power?
- D
  Dean HannaAug 18, 2025
  If your Craftsman Snow Blower is losing power, check the following: * Ensure the spark plug wire is firmly connected. * Check the gas cap vent and clear it if it's plugged.
R
Robin DayAug 23, 2025
Why is my Craftsman 31AM2T6D799 Snow Blower engine running erratically?
- S
  Samantha TranAug 23, 2025
  An erratic engine in your Craftsman Snow Blower can stem from a few causes: * The engine might be running on choke. Move the choke control to the RUN position. * There might be water or dirt in the fuel system. Run the engine until the fuel tank is empty and then refill it with fresh fuel.
C
Caitlin OrrAug 29, 2025
What to do if my Craftsman 31AM2T6D799 Snow Blower unit fails to discharge snow?
- M
  michelle26Aug 29, 2025
  If your Craftsman Snow Blower isn't discharging snow, here's what you can check: * The chute assembly might be clogged. Stop the engine, disconnect the spark plug wire, and clean the chute and inside of the auger housing using a clean-out tool or stick. * A foreign object may be lodged in the auger. Stop the engine immediately, disconnect the spark plug wire, and remove the object. * The auger control cable may be out of adjustment. Adjust the auger control cable. * The auger belt might be loose or damaged. Replace the auger belt.
W
William RichardsSep 5, 2025
What to do if my Craftsman 31AM2T6D799 Snow Blower has excessive vibration?
- S
  Samantha SmithSep 5, 2025
  If your Craftsman Snow Blower is vibrating excessively, stop the engine immediately, remove the key, and check for loose parts or a damaged auger. Tighten all bolts and nuts and repair as needed.