EasyManua.ls Logo

Craftsman 320.17543 - Electrical Safety

Craftsman 320.17543
48 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
TOOL USE AND CARE SAFETY
I L_ WARNING: BE SURE to read end understand all Instructions before
operating these reuters. Failure to follow all instructions listed below may result
In electric shock, fire andtor serious personal injury.
1 ALWAYS use clamps or other practical ways to secure and support the workplace
to a stable platform, Holding the work by hand or against your body Is unstable and
may teed to loss of control
2 DO NOT force the tool. Use the correct tool and bit lor your application. The correct
tooland bit w]!l do Ihe Jobbelier and safer at the rats for which IIIs designed
3 DO NOT use the tool It switch does not turn ii "On" or"Off", Any tool 1halcannot be
controlled v_ththe switch Is dangerous and must be repaired
4 DISCONNECT the plug from the poWer source before making any adjustments,
ehanglng accessories or storing the tool. Such preventive safety measures reduce
the risk of starling the tool accidentally
5 NEVER leave the tool running. ALWAYS turn It oft_ DO NOT leave the |eel unll_it
comestoa compie{e slop
6 STORE Idle tools out of the reach of chlfdren end other untrained parsons_Tools
are dangerous In the hands of untrained users
7 MAINTAIN tocls wtth cara. Keep cutllng tools sharp and clean Prepedyma_nta_ned
toolswith sharp cutting edges are less likely tobind and are easier to central
8 CHECK for mlsallgnmant or binding of moving parts, breakage of parts, and any
other cond_tion{hatmay affect the too_'soperation if damaged, have the too{serviced
before using Many accidents are caused by poorlymaintained tools
g USE ONLY accessories that are recommended for this tool. Accessories that may be
suttable for one toolmay become hazardouswhen used on another tool
ELECTRICAL SAFETY
I Z_ WAR NING: Do not permit fingers to touch the terminals of plug when ]tnstamng or removing the plug from the oulIet.
J
1 Double insulated tools are equipped with a polarized plug (one blade Is wider
than the other).Thls plug will fit In a polarized outlet only one way. If the plug
does not {it fuily in the culler, reverse the plug If it sili_ does not fit, contact aquailfled
electrician to Install a polarized outlet Do net change the plug In any way
2 Double Insulation [] eliminates {he need for the three-wire grounded power
cord and grounded power supply system, Applicable onty to Class II (double-insulated)
toots This router motor fs double Insulated,
Z_ WARNING: Double Insulation DOES NOT take the place of norms! safety |
precautions when operating this tool
J
5
17543

Table of Contents

Related product manuals