Why is my Craftsman Trimmer engine overheating?
If your Craftsman Trimmer engine overheats, check the following: * Ensure the engine oil level is adequate and fill the crankcase with the correct oil if it's low. * Make sure that the airflow is not restricted by cleaning the area around and on top of the engine.
What to do if the drive-belt slips on my Craftsman Trimmer?
If the drive-belt slips on your Craftsman Trimmer, it is likely worn or stretched. Replace the drive belt.
General| Engine Type | 4-Cycle |
|---|---|
| Cutting Width | 12 inches |
| Weight | 17.6 lbs |
| Power Source | Gasoline |
| Starting System | Recoil |
| Engine Displacement | 29 cc |
| Fuel Tank Capacity | 10.1 fl oz |
Key warnings and responsibilities for safe operation of the machine.
Warning about chemicals in engine exhaust and vehicle components.
Safe practices for operation, including operator zone, area inspection, and attire.
Precautions to protect children from hazards related to lawn edgers.
Safe procedures for handling, fueling, and storing gasoline.
Safety measures for performing maintenance and inspections.
Discourages tampering with engine settings and governor for safety.
Information regarding EPA and California emissions compliance.
Description of graphical symbols indicating hazards and precautions.
Details on spark arrestor requirements and availability.
Steps for attaching and securing the main handle to the unit.
Instructions for properly routing the control cable.
Method for attaching the control cable to the handle assembly.
Securing the cable that controls the blade depth.
Installing the guide for the engine's starter rope.
Adjusting the blade angle for different edging types.
Description of primary controls like blade control and depth lever.
Details on curb height and bevel adjustment levers.
How to operate the recoil starter and primer.
Statement of adherence to American National Standards Institute (ANSI).
Procedure to safely stop the engine and blade.
Step-by-step guide for igniting the engine.
Instructions on how to perform the edging operation effectively.
How to adjust the wheel for edging along curbs.
Setting the blade angle for creating beveled edges.
Using the optional feature for creating trenches.
Table outlining recommended service intervals and tasks.
Recommendations for general upkeep, warranty, and adjustments.
Instructions for cleaning and maintaining the engine.
Points and frequency for lubricating wheels and pivot points.
Procedure for lubricating the bearing block.
How to inspect, care for, and service the edger blade.
Step-by-step instructions for replacing the drive belt.
Guidelines for storing the equipment during the off-season.
Steps to prepare the engine for long-term storage.
Steps to prepare the edger unit for storage.
Common issues and remedies for engine failure to start.
Solutions for erratic running, overheating, and operational skips.
Addressing vibration, belt slip, and poor idling.
To Next Page