EasyManua.ls Logo

Crane BARNES SP33 Series - User Manual

Crane BARNES SP33 Series
10 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
A Crane Co. Company
BARNES
®
INST
ALLATION MANUAL
Submersible Sump / Effl uent Pump
IMPORTANT! Read all instructions in this manual before operating pump.
As a result of Crane Pumps & Systems, Inc., constant product improvement program,
product changes may occur. As such Crane Pumps & Systems reserves the right to
change product without prior written noti• cation.
420 Third Street 83 West Drive, Bramton
Piqua, Ohio 45356
Ontario, Canada L6T 2J6
Phone: (937) 778-8947 Phone: (905) 457-6223
Fax: (937) 773-7157 Fax: (905) 457-2650
www.cranepumps.com
Form No. 112251-Rev. P
Series: SP33
.33 HP, 3450 RPM, 60 Hz.
.2 HP, 2850 RPM, 50 Hz.

Table of Contents

Questions and Answers

  • A
    Antonio Bishop DDSAug 11, 2025
    How to troubleshoot a Crane Water Pump that will not run?
    • L
      Laura HawkinsAug 11, 2025
      If your Crane Water Pump isn't running, start by checking all electrical connections to ensure they are secure. Have an electrician measure the current in the motor leads. If the current is within ±20% of the locked rotor Amps, the impeller is likely locked. If the current is 0, the overload may be tripped. Remove power, allow the pump to cool, and then recheck the current. Also, ensure the liquid level is at least equal to the suggested turn-on point.
  • M
    Mark StaffordAug 20, 2025
    Why does my Crane BARNES SP33 cycle too frequently?
    • W
      wrightnicoleAug 20, 2025
      Your Crane Water Pump might be cycling too frequently because of several reasons. Check valve might be stuck closed or installed backwards, fixtures may be leaking, or ground water may be entering the basin.
  • H
    heather65Aug 30, 2025
    What to do if the Crane BARNES SP33 float movement restricted?
    • E
      Erica MillerAug 30, 2025
      If the float movement is restricted in your Crane Water Pump, reposition the pump or clean the basin to provide adequate clearance for the float.

Crane BARNES SP33 Series Specifications

General IconGeneral
SeriesSP33
Horsepower1/3 HP
Voltage115V
Impeller MaterialThermoplastic
PhaseSingle-Phase
Cord Length10 ft
Switch TypeAutomatic

Related product manuals