To Next Page
B
Brooke WhiteAug 11, 2025
How to troubleshoot a Crane Water Pump that will not run?
- KKatie Jackson MDAug 11, 2025
If your Crane Water Pump isn't running, start by checking all electrical connections to ensure they are secure. Have an electrician measure the current in the motor leads. If the current is within ±20% of the locked rotor Amps, the impeller is likely locked. If the current is 0, the overload may be tripped. Remove power, allow the pump to cool, and then recheck the current. Also, ensure the liquid level is at least equal to the suggested turn-on point.
General
