Page 27 of 62
“Lighting #” - Lighting / P.O.S. Display Control
This function is used to turn the lights (if supported) and P.O.S. Display Message off during selection blocking
period 1. 0 = disable or on; 1 = enable or off.
Press key number 4 and the “#” will start flashing.
Press key number 2 or 3 to scroll between “Lighting 0” and “Lighting 1”. Press key number 4 with the display
showing the setting you wish to use. Display will return to “Lighting X”. Press key number 1 to return to
“Select Block 1”. Press key number 2 to scroll to “Select Block 2”.
*”Select Block 2" - BLOCK SELECTION BANK 2 ROUTINE
Please refer to the Programming Guide for detailed information.
To Next Page
Loading...
Need help?
General
