Page 33 of 62
NEW VMC INSTALLATION
Disconnect power to the Vender when replacing the VMC. Once all connectors are positioned on the new
VMC apply power to the Vender. To Set Model Number. On power up the Display will show
NO MODEL SET
A=select *=save
Press Key A to scroll through available model numbers 5800-4, 3800-4, 5800-E4 (export), 3800-E4 (export).
With the model number of the vender in the Display you are installing the VMC in, press the “”
Key to save.
VMC SOFTWARE UPDATE PROCEDURE
The VMC is flash programmable. Note: Updating the VMC is done with a USB flash drive. There is no menu
to update the VMC Board software. The following information describes how to update the VMC software.
All new software revisions to the peripheral Cabinet Control Boards (AC Distribution Box Cabinet Control
Environmental Board, Cabinet Control X Motor Board, Cabinet Control Y Motor Board, Cabinet Control Port
Board, & Cabinet Control Cup Board) will automatically update via the VMC. Important: USB’s containing
software are sensitive to Electrostatic Discharge (ESD). Failure to handle the USB carefully could cause
damage, which may result in a Vender being put out of service.
ALWAYS GROUND YOURSELF ON THE VENDER CABINET BEFORE INSTALLING OR REMOVING THE USB FROM
THE VMC. A USB CAN BE USED TO PROGRAM MANY VENDERS. ALWAYS TURN POWER OFF BEFORE
INSTALLING USB IN THE VMC. Important Notes: Use the programming section of the manual to program the
Vender.
The VMC includes 7 Diagnostics lights providing information on operational status and where to focus problem
solving efforts.
1. USB Software Installation:
a. Power down the Vender. Ground yourself on the Vender Cabinet.
b. Install the USB in the VMC USB Port.
c. Press and hold the VMC Service Switch (SW1). While holding the Service Switch turn the power
on to Vender.
d. Once the Machine powers on, release the Service Switch.
e. During software updating the VMC 7 Diagnostic lights (D4 to D10) will flash on and off for
approximately 15 seconds.
f. Once install is complete all 7 VMC Diagnostic lights will be flashing on and off.
g. Remove the USB flash drive from the VMC. Note: power does not need to be off to remove the
USB.
h. If only D4 and D10 Diagnostic lights are on at this time, the install was not completed. Repeat
steps a. through h.
To Next Page
Loading...
Need help?
General
