Page 22 of 101
Touch the Menu Bar for Card Reader A or B to turn on your MDB
Card Reader option.
If you have one MDB Card Reader choose Card Reader A. If you have
two Card Readers make sure Card Reader B is both capable of and
set to communicate as Card Reader B.
Once you turn on either Card Reader A or B Card Revalue will
appear allowing you to choose an option to adding value to a Card.
This is seldom used and currently is only available in a closed
network and not used with Credit Cards.
Touch the Onboard Cashless
Menu Bar Enable to toggle
between Off and On.
An Onboard Card Reader is a
built in Card Swipe on the
front of the Machine that
plugs directly into the Atlas
Controller at J42.
Crane Onboard Cashless accepts NFC
(Tap and Go) transactions. If you
have a separate NFC Reader
installed, as long as the Onboard
Card Reader is assigned and enabled
and the NFC Reader Cable is
connected to a USB port on the Atlas
Controller the NFC Reader will work.
The Radio should be plugged into
USB 1. We recommend connecting
the USB Cable for the NFC Reader
into USB 2.
View of Atlas H Board as installed on Service Door
To Next Page
Loading...
