Page 9 of 101
change available for payback to the customer. Recommended minimum amount is $17.00
(1 roll each of 5¢; 10¢; 25¢ coins). This minimum amount of change should remain in the
Machine at all times.
Adding Initial Change Load
1. Enter the required PIN: 3333.
2. From the Operator/Technician Main Menu touch the Monetary Menu
Bar on the Screen.
3. Touch the Coins In/Out Menu Bar.
4. Increase the amount of change available by inserting coins in the chute
on the top of the Coin Mech. Total count for each coin and value of the
coin accepted should increase as coins are added.
5. Press Back to exit and return to the Monetary Menu.
6. For additional information about the Coin Mechanism, refer to the
manufacturer’s instructions.
SET INHIBIT TIMES
Allows the service technician to set times when sales will be inhibited. From the
Operator/Technician Main Menu touch Timed Events > Time of Day Events >
Inhibit. Touch Create Event, then Enable State, Start Time, Stop Time, Days of
Week, Selections to be inhibited and then touch Save this Event.
TEST VEND
Allows the service technician to perform a complete test on a Single Product or
All Products when a product is present in all selections of the vender. The
Service Door must be opened all the way so the Discharge Door does not hit the
Delivery Port while Test Vending. Go to Test > Test Vend > Test Single Product
or Test All Products and the machine will test your selection. You will need to
catch the product whenever you test with the Service Door open.
Note: the Motor Power Interrupt Switch (left switch in bracket) must be engaged
for movement to occur during test when the service door is open.
Note: when testing with the service door open and a product is physically
dispensed from the tray, you must catch the product when it goes through the
Delivery Port Door and place it in the Port Assembly.
To Next Page
Loading...
