ASSEMBLY & USE
ALWAYS use fresh cool water when operating the humidifier.
1. Turn Water Tank upside down, unscrew Water Tank Cap and fill with cool water only.
ALWAYS HOLD WATER TANK WITH TWO HANDS WHEN FULL.
DO NOT fill water all the way to the rim.
DO NOT use hot water.
DO NOT add any medication, essential oils, or salt.
DO NOT pour water into Mist Lid.
2. Screw Water Tank Cap back onto Water Tank and turn the tank over to place on
Humidifier Base, making sure it fits together securely.
Note: Do not attempt to move the humidifier while Water Tank is placed on the
Humidifier Base. Doing so may cause leakage of water and/or Humidifier Base to
overfill.
3. Plug the power cord into a wall socket and turn on the unit by pressing the power
icon on the humidifier base.
4. The Power Indicator Light will beep one time and illuminate blue indicating that
there is enough water in the Humidifier Base and mist will begin emitting on the low
setting through the Mist Lid.
1
st
Press: Humidifier ON LOW
2
nd
Press: Humidifier ON HIGH
3
rd
Press: Humidifier OFF
5. The light Indicator Icon
1
st
Press: Turns on light and cycle through colors
2
nd
Press: Freezes the last color is was on
3
rd
Press: Turns off the light
* The light can function without the mist function on
6. When the humidifier runs out of water, the Power Indicator Light will flash red. This is a
safety feature to prevent the humidifier from possibly overheating and damaging
the Nebulizer. Press the power indicator and it will beep on time and power off.
Unplug the unit before removing and refilling the water tank.
A NOTE ABOUT HUMIDITY
To reduce excessive humidity or condensation, especially in small rooms, leave the room
door open and adjust mist intensity to the low output setting.
Too much humidity in the room may allow moisture to accumulate on surfaces where
bacteria and fungi can grow. Moisture that gathers may also damage furniture and
walls, especially wallpaper.
To Next Page
Loading...
