Need help?Do you have a question about the Crate VFX5112,VFX5212 and is the answer not in the manual?
Power| output power rating | 50 Watts RMS |
|---|---|
| power requirements | 120 VAC, 60 Hz, 200VA |
Sound| signal to noise ratio | 70 dB |
|---|---|
| gain channel A | 62 dB |
| gain channel B | 98 dB |
Equalization| EQ Channel A Treble | 30 dB range @ 10 kHz |
|---|---|
| EQ Channel A Mid | 6 dB range @ 600 Hz |
| EQ Channel A Low | 30 dB range @ 80 Hz |
| EQ Channel B Treble | 10 dB range @ 4 kHz |
| EQ Channel B Mid | 10 dB range @ 1 kHz |
| EQ Channel B Low | 12 dB range @ 100 Hz |
| presence | 18 dB range @ 20 kHz |
Speaker Specifications| speaker configuration | 1 X 12” |
|---|---|
| speaker power | 60 W |
| speaker impedance | 16 ohm |
Size and Weight| width | 23 inches |
|---|---|
| height | 19 inches |
| depth | 10 inches |
| weight | 48 lbs |
Power| output power rating | 50 Watts RMS |
|---|---|
| power requirements | 120 VAC, 60 Hz, 200VA |
Sound| signal to noise ratio | 70 dB |
|---|---|
| gain channel A | 62 dB |
| gain channel B | 98 dB |
Equalization| EQ Channel A Treble | 30 dB range @ 10 kHz |
|---|---|
| EQ Channel A Mid | 6 dB range @ 600 Hz |
| EQ Channel A Low | 30 dB range @ 80 Hz |
| EQ Channel B Treble | 10 dB range @ 4 kHz |
| EQ Channel B Mid | 10 dB range @ 1 kHz |
| EQ Channel B Low | 12 dB range @ 100 Hz |
| presence | 18 dB range @ 20 kHz |
Speaker Specifications| speaker configuration | 2 X 12” |
|---|---|
| speaker power | 60 W |
| speaker impedance | 8 ohm |
Size and Weight| width | 28 inches |
|---|---|
| height | 21 inches |
| depth | 11 inches |
| weight | 58 lbs |
Connect instrument, adjust Volume, Treble, Mid, and Bass for Channel A.
Select channels, adjust Gain, Level, EQ for Channel B, and choose DSP effects.
Adjust Presence, Master Level, and control amplifier power states (On/Off, Standby).
Features AC Line, Footswitch, Line Out/In, and External Speaker jacks for connectivity.
Adjusts amplifier output impedance to match connected speakers.
Guide on using the footswitch to save and recall DSP effect settings for each channel.
Overview of vacuum tube development and classification of preamp/power tubes.
Guidance on when to replace tubes and the importance of proper bias adjustment.
Recommendations for prolonging tube life and maintaining amplifier health.
Recommended knob positions for clean tones and quiet operation.
Recommended settings for bluesy crunch and rhythmic distortion tones.
Recommended settings for achieving sparkly clean and unique sounds.
Details amplifier's power output rating and signal-to-noise performance.
Provides gain levels and equalization frequency ranges for both channels.
Lists presence range, speaker specs, and types of preamp/power tubes used.
Specifies voltage, power consumption, size, and weight of the amplifier.
To Next Page
