35
6. Add the device to the software.
7. Complete camera calibration and alignment.
8. Generate files with the required settings and parameters.
9. Start the operation.
Work with TF Card
Generate engraving or cutting files (G-code) through LightBurn and save the files to the first-
level directory of the TF card. Before powering on the device, insert the TF card into the card
slot, and ensure the triple switch is turned on. Once the power is on, the device will beep
twice. After initialization, the device will enter standby mode, and the indicator light will turn
green.
Steps:
1. Assemble the device.
2. Place the materials.
3. Focus the laser module using the multi-level fixed focus block.
4. Install the required software.
5. Add the device to the software.
6. Generate the files with the correct parameters.
7. Save the G-code to the TF card.
8. Insert the TF card into the device.
9. Power on the device.
10. Press Frame to preview the target area.
11. Start the operation.
To Next Page
Loading...
